Replaced cases that have deteriorated in the key case of genuine sockli "Peugeot 206, 307 keyless case flip type external goods"

There are many types of remote control keys that can control the doors and unlocks remotely, such as keyless entry, are made of plastic.If you carry the key every day, the case part of the remote control will deteriorate.In particular, the button portion is integrated with the case, and the button part that presses the internal microscope with the elasticity of the plastic may break the button part.The key of my car's car is also this pattern.The part that pressed the switch deteriorated, completely tattered and the inside was exposed.If the button part is a switch that is separated from the case, it is unlikely that such deterioration will occur, but it is often seen that this kind of case was the mainstream for a while.

If you take a key case, take it to a dealer, but the key of your car (Peugeot 206) has an immobilizer ( *), and the key tip of the key is broken, removing it and removing only the case.It is a bit confusing, using a spare key to start the engine.It is only necessary to have a key case and a key case, but if you ask a dealer to repair it, it is possible that the whole key will be replaced with a new one.The key production with an immobilizer is surprisingly expensive and time -consuming.I wanted to avoid it because the car could not move.

I expected that it would not be so difficult in terms of work if I simply replace the key case, so I decided to replace it on my own this time.In some key cases, genuine products can be ordered as parts depending on the model.

This time, I got a third -party part that is compatible with genuine.If you look at the Internet, you will find key cases of various models.It is important to note that the product called the key cover is a cover that covers the whole, so if you want to replace the case like this time, do not choose.

汚くて申し訳ないが、長年の使用でボロボロになってしまった愛車のキーカバー。スイッチ部分のカバーが完全に壊れてしまった新品のキーカバーでは、このようにスイッチになっている。このスイッチ部の薄い部分がネック

In the series of your favorite car, the key case has been changed in the latter model, and it is a slightly luxurious type.I chose this case for a change of mood (the internal remote control part is the same shape).In the pocket, store the key in the case, and press the button to flip the key part and jump out like a jack knife.This does not protect the key part.When the key was destroyed before, the key tip was slightly deformed just by dropping it to the asphalt.This function is also grateful to avoid breaking the key tip when dropped.

The point is that the key case selected this time has a blank key.I had destroyed the tip of the key before, so I wanted to make a new key part.However, the key of the car is a special key with holes at the tip, and there is no blank key in the locksmith.If you have a blank key, you can use it simply by having a key shape in a locksmith.It is a product that I wish and I hope.

今回購入したRK.Planning「プジョー206、307用キーレスケースフリップタイプ　社外品」（価格：2580円）。キー部分がフリップするタイプでブランクキーが付属するブランクキー先端には穴が空いている。この特殊なブランクキーが付属するのはありがたい

The only work is to disassemble the old case and transplant the remote control substrate, the immobilizer chip and keys inside the new case.This time, I made a matching key from the blank key, but I usually need to transplant the keys I used so far.In the remote control key, the battery is used, so it is best to replace it with a new one at this opportunity, but if you replace the battery, the remote control may be initialized (reset), so check the necessary operation after initialization in the manual.I want you to replace it before.If you do not know the operation after initialization, the remote control will not be available, so it is troublesome.

Imbalizer chip (transpondoner tip) may be embedded in places where it is difficult to understand depending on the vehicle type or extremely small.Therefore, be careful not to lose it in Zettai.I want to start working after knowing whether or not the car immobilizer is, so as not to throw away the old case without knowing the existence of a chip.Also note that chips are easily cracked.If you lose or break the immobilizer chip, you will have to make a new one, and there is no point in replacing the case with DIY.

The key case I chose this time was a gimmick that flipped the key, so the button and spring installation on that part were a little troublesome.

古いケースからリモコンの基板とイモビライザーチップを取り出す基板には電池（CR2016）が付いている。この機会に交換しておくとよい電池の交換前には、念のためリモコンの初期化操作を調べておこう。マニュアルを参照するかディーラーに聞けば教えてくれるはずだ新しいケースに基板を装着する。ボタン部分を合わせてはめこむイモビライザーチップを所定の場所に装着する。多くはキーに近い位置にはめ込み部分があるこのキーはボタンを押すとキーがフリップするタイプなので、テンションがかかるようにバネをうまくはめ込む必要があるあとはねじ止めすれば完成キーケースを新しくしたリモコンキー。ちょっとだけ新車を買った時の気分が味わえる

I have been driving since I didn't have a remote control key, so I didn't think it would be particularly inconvenient even after the button was broken, so I used it only with a spare key without using a remote control key for a while.I realized that it was convenient to use the key.The type of key selected this time flip is larger than the previous case, but the key tip is protected, so it has a sense of security, making it easier to put it in a pocket with a shape that does not appear.If you can choose a flip type case like this time, I would recommend it.

Only one drawback.In this key case, it was a little difficult to use because the opening and closing switch could not be determined by groping.

If the key is not enough to renew the key, but only the case is getting worse, the key with an immobilizer like this time will be surprisingly easy to exchange cases, so why not try it?

*: In cars equipped with immobilizer, the key turns but the engine does not start unless a special key is used for each car.The immobilizer is a vehicle theft system that has a mechanism that does not start unless the ID code matches the engine and the transpondoner chip inside the key and does not match the ID code.In the unlikely event that the key is eliminated, the individual immobilizer ID (keep it separately with a regular card, etc.) must be re -created.